TB7100
TB7100 – Options and Accessories
To test transmissions or enhance your TB7100 base station/repeater, your organization may require a few accessories or optional add-ons.
Such accessories and options include:
- Microphone
- Tone Remote
- Calibration Test Unit
- Tool Kit
- Wall Mount Kit
- Programming Kit
- Programming Cable
Microphone
A microphone is required for test transmissions, and plugs into the user interface on the front panel. The microphone can be configured to transmit over the air or as line audio.
Modules/Options
Tone Remote
The tone remote module enables a despatch console (desktop controller) to control a remote base station/repeater via either a 2-Wire or 4-Wire leased circuit. The tone remote takes up only 2U in a 19 inch rack and can contain one or two tone remote modules.
Service Accessories
Calibration Test Unit
To configure, run-up and test the TB7100 for operation, the calibration test unit is required.
- Control Panel Board Remover
- Spanner 5/16 Torx-Driver T8
- Torx-Driver T10
- Torx-Driver T20
- Screwdriver Pozidrive 2
- Screwdriver Blade 5.5mm
- Tuning Tool Ceramic 2.2mm
- Tuning Tool 0.9 x 0.4mm
- Tuning Tool Johanson 8877
- Nut driver M3 5.5mm
- Tool bag
Programming Accessories
Wall Mount Kit
This kit contains additional brackets and screws to enable wall mounting.
Programming Kit
The programming kit contains service kit, CD and cable.
Programming Cable
The programming cable is available separately.
DMR
